Homogeneous floor Construction Instructions

1.The construction requirements of the homogeneous vinyl floor are higher than that of the composite commercial floor, and it is more different from the floor tiles and wooden floors. Please hand it over to a professional construction team for construction. The main aspects are: color difference inspection, selection of adhesives, floor scratch protection, Waste edges on both sides of the floor, floor pre-laying time, construction environment temperature above 15 degrees Celsius, ground foundation, floor hardness, etc.;

xthf (1)

2.Construction procedures include: original ground inspection and treatment; self-leveling construction; self-leveling ground inspection and treatment; floor laying, cleaning and maintenance;

3.Pre-laid floor: After arriving at the construction site, unfold the floor, pre-lay at room temperature for 2-24 hours, check the color difference and release the stress of the same penetration floor, because the floor will be uneven after transportation and laying, and it needs to be pre-laid and flattened. Glue, respond in time if there is a problem, do not hard pavement;

4.The floor is required to be laid in reverse according to the floor with the similar volume number. If the color difference is found, adjust the direction or adjust the room area. With the maturity of construction, almost all experienced construction workers will pay attention to the problem of chromatic aberration, and respond in time if there is a problem, do not rigidly pave;

5.Waste edge treatment. Because there is no glass fiber in the homogeneous floor, the edges on both sides are not 100% straight, and the waste edge needs to be 1.5-3 cm before aligning – seam welding line. In order to save trouble, many construction workers use it directly on the opposite side, and there are many problems. For example, when the area is large, the seams are not aligned properly;

6. Different hardness and softness: Because the content of plasticizers in winter and summer is slightly different, the hardness of products produced in winter and those produced in summer are somewhat different, especially for some stock models after the season changes. Because small square orders are delivered from stock, it is inevitable that they will be sold off-season. If this happens, please extend the pre-laying time at room temperature;

7. It must not be cross-constructed. There is no transparent wear-resistant layer on the homogeneous floor, and the surface is easily scratched by hard objects. The floor needs to be protected during construction and when moving objects. In daily use, dust-removing foot mats need to be placed at the door. , Furniture and chairs cannot use materials that are in contact with the bottom of metal materials;

8. There is no glass fiber and the material of the homogeneous floor is hard. It needs to use special glue with strong viscosity and easy curing and compact and exhaust. If it is not on the wall during construction, a gap should be reserved between the wall and the wall to prevent the floor from arching due to thermal expansion and contraction.

9. Our floors are all treated with wax-free surface treatment. After construction, cleaning and daily maintenance do not require waxing, which saves maintenance costs.

xthf (2)

10. Please pay attention to the following when using the homogeneous floor: 1. Avoid sharp objects from touching the floor, and furniture and chairs need to be made of flexible floor-contacting materials; 2. For daily cleaning of stubborn stains, please use neutral detergent and water for cleaning; after using for a long time, please use a mop for maintenance; 3. If you are in direct contact with ultraviolet rays for a long time, please use curtains or other shades to avoid affecting the color of the floor.


Post time: Jun-22-2022